The world’s tiniest RGB LED cube

This 4x4x4 cube measures only 2cm on each side.

If you read Atmel’s blog, chances are that you’ve seen a programmable LED cube. Given the amount of soldering involved, adequate space between each light would seem like a necessity. Hari Wiguna, however, decided that he could make a 4x4x4 cube measuring only 2cm on each side. In other words, as seen in the first video below, it would roughly fit on a quarter.

This build took Wiguna “months to build, but it’s finally done,” and, unless he hears differently, it is the smallest 4x4x4 LED cube in existence. Soldering, as shown in the second video, seems that it was quite a nightmare, but at least he had a custom PCB on which to set his LED stacks once they were assembled. For work that small, he needed a fine-tip soldering iron, but had to actually build his own set of jigs to assemble everything correctly.

The circuit, seen in the third video uses an Arduino Nano (ATmega328) to control the 64 RGB LEDs used. It’s a very clever setup, modeled after the Charliecube design found here. The four stacked LEDs are each rotated 90 degrees to each other, allowing its diode property to separate out each light’s signal.

The resulting animations are quite impressive — amazing for something this size! Check out the three clips below for even more background on this tiny wonder.

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s